Inhoudsopgave
Advertenties
MRT 1432 - 1635 M
EN
C
6
a
-
Check rotation reduction gear oil
C
6
a
-
(400°)
Position the lift truck, with turret aligned, on a
level surface,
retract and raise telescopic boom completely,
and then turn the turret to the right by
+/- 60°, for better access to the rotation
reduction gear filling points (Fig.C6a).
Stop the I.C. engine and wait for the hydraulic
oil to cool down.
To check the oil level in the reduction unit:
Relieve the level plug 2 (fig. C6a/1).
The level is correct when the oil surfa-
ces and flows through the port of level
2 (fig. C6a/1) add oil.
Trough the breater and flitting oil hole
1, (fig. C6a/1) if necessary, (see
"Lubricant").
Then refit the topping up and level caps.
1
S S eries
C
6
a
-
Controle van de olie van de
C
6
a
-
rotatiereductor (400°)
Plaats de heftruck, met uitgelijnde zwenkkop,
op een vlak terrein, schuif de telescopische
arm helemaal in en hef hem helemaal op en
draai dan de zwenkkop naar rechts over +/-
60°, om beter bij de punten te kunnen komen
waar de rotatiereductor gevuld moet worden
(fig.C6a); zet de thermische motor uit en wacht
tot de hydraulische olie afgekoeld is.
To check the oil level in the reduction unit:
Relieve the level plug 2 (fig. C6a/1).
The level is correct when the oil surfa-
ces and flows through the port of level
2 (fig. C6a/1) add oil.
Trough the breater and flitting oil hole
1, (fig. C6a/1) if necessary, (see
"Lubricant").
Then refit the topping up and level caps.
NL
C
C
Parkér trucken med oprettet tårn på et
jævnt underlag. Indtræk og løft teleskopar-
men fuldstændigt og drej herefter tårnet
mod højre (+/- 60°) for at forbedre adgan-
gen til punkterne for påfyldning af reduk-
tionsgearet for rotation (fig. C6a). Sluk
varmemotoren og vent, indtil hydraulikolien
er afkølet.
To check the oil level in the reduction unit:
Relieve the level plug 2 (fig. C6a/1).
The level is correct when the oil surfa-
ces and flows through the port of level
2 (fig. C6a/1) add oil.
Trough the breater and flitting oil hole
1, (fig. C6a/1) if necessary, (see
"Lubricant").
Then refit the topping up and level caps.
C6a
1
2
DK
6
a
-
Kontrollér olieniveauet i
6
a
-
reduktionsgearet for rotation
(400°)
2
C6a/1
3
23
Advertenties
Inhoudsopgave
