Advertenties
13 Contour- en puntdefinities........................................................................................................ 355
13.1 Puntentabellen............................................................................................................................... 356
13.1.1
Puntentabel in het NC-programma selecteren met SEL PATTERN................................................ 357
13.1.2
Cyclus met puntentabel oproepen.........................................................................................................357
13.2 Overlappende contouren................................................................................................................ 358
13.2.1
Basisprincipes.............................................................................................................................................358
13.2.2
Subprogramma's: overlappende kamers..............................................................................................358
13.2.3
Oppervlakte van som................................................................................................................................ 359
13.2.4
Oppervlak verschil......................................................................................................................................360
13.2.5
Oppervlak zaagsnede................................................................................................................................360
13.3 Eenvoudige contourformule............................................................................................................362
13.3.1
Basisprincipes.............................................................................................................................................362
13.3.2
Eenvoudige contourformule invoeren................................................................................................... 364
13.3.3
Contour afwerken met SL- of OCM-cycli..............................................................................................365
13.4 Ingewikkelde contourformule......................................................................................................... 366
13.4.1
Basisprincipes.............................................................................................................................................366
13.4.2
NC-programma met contourdefinitie selecteren................................................................................ 369
13.4.3
Contourbeschrijving definiëren............................................................................................................... 370
13.4.4
Ingewikkelde contourformule invoeren................................................................................................. 371
13.4.5
Overlappende contouren.......................................................................................................................... 371
13.4.6
Contour afwerken met SL- of OCM-cycli..............................................................................................374
13.5 Patroondefinitie PATTERN DEF...................................................................................................... 375
13.5.1
Toepassing.................................................................................................................................................. 375
13.5.2
PATTERN DEF invoeren........................................................................................................................... 375
13.5.3
PATTERN DEF gebruiken......................................................................................................................... 376
13.5.4
Afzonderlijke bewerkingsposities definiëren........................................................................................377
13.5.5
Afzonderlijke reeks definiëren................................................................................................................. 378
13.5.6
Afzonderlijk patroon definiëren...............................................................................................................379
13.5.7
Individueel kader definiëren.....................................................................................................................381
13.5.8
Volledige cirkel definiëren........................................................................................................................ 383
13.5.9
Steekcirkel definiëren................................................................................................................................ 384
13.5.10 Voorbeeld: cycli in combinatie met PATTERN DEF toepassen........................................................385
13.6 Cycli voor patroondefinitie............................................................................................................. 387
13.6.1
Overzicht...................................................................................................................................................... 387
13.6.2
cyclus 220 PATROON OP CRKL.............................................................................................................388
13.6.3
cyclus 221 MODEL OP LIJN....................................................................................................................391
13.6.4
Cyclus 224 VOORBEELD DATAMATRIX CODE....................................................................................395
13.6.5
Programmeervoorbeelden....................................................................................................................... 401
18
Inhoudsopgave
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Advertenties
