IT
Esecuzione dello sfiato dell'impianto
di alimentazione con prefiltro del
carburante (D5/3.3)
Sfiato del prefiltro del carburante con la
pompa a mano del carburante (D5/3.3).
Lo sfiato del prefiltro del carburante deve
essere eseguito soltanto
• se il serbatoio del carburante è vuoto
• se il filtro del carburante è stato sostituito.
- Svitare il tappo del serbatoio del
carburante.
- Posizionare il recipiente di raccolta sotto il
prefiltro del carburante.
- Aprire completamente la valvola di
intercettazione 3 (D5/3.3).
- Aprire la valvola di sfiato 2 (D5/3.3).
- Azionare la pompa a mano del carburante
1 (D5/3.3) solo fino a quando dalla valvola
di sfiato 2 (D5/3.3) fuoriesce carburante
privo di bolle. Interrompere l'azionamento
della pompa.
- Chiudere la valvola di sfiato 2 (D5/3.3).
- Chiudere il tappo del serbatoio del
carburante.
-
Avviare
il
motore.
L'impianto
alimentazione effettua automaticamente
lo sfiato.
Dopo l'avviamento del motore interrompere
l'azionamento della pompa a mano del
carburante. In caso contrario la pompa a
mano può subire dei danni.
EN
Bleeding the fuel system with fuel prefil-
ter (D5/3.3)
Bleeding the fuel prefilter using the
manual fuel pump (D5/3.3).
The fuel prefilter must only be bled when:
• the fuel tank is empty or
• the fuel filter has been replaced.
- Unscrew the fuel tank filler cap.
- Place the collector underneath the fuel
prefilter.
- Open shutoff valve 3 (D5/3.3) fully.
- Open bleed nipple 2 (D5/3.3).
- Only press manual fuel pump 1 (D5/3.3)
until the fuel escaping from bleed nipple
2 (D5/3.3) is free of bubbles. Do not conti-
nue to pump.
- Close bleed nipple 2 (D5/3.3).
- Close the fuel tank filler cap.
- Start the engine.
The fuel system is bled automatically.
di
Do not continue to press the fuel hand pump
after the engine has started. This could
otherwise damage the hand pump.
D5/3.3
3-54
www.duma-rent.com
NL
Het verluchten van het toevoersysteem
met brandstofvoorfilter (D5/3.3)
Verluchten van de brandstofvoorfilter met
handmatige brandstofpomp (D5/3.3).
Het verluchten van de brandstofvoorfilter
dient alleen uitgevoerd te worden
• als de brandstoftank leeg is
• als de brandstoffilter vervangen is.
- Draai de dop van de brandstoftank los.
- Plaats het opvangbakje onder de
brandstofvoorfilter.
- Open de opvangklep volledig 3 (D5/3.3).
- Open de verluchtingsklep 2 (D5/3.3).
- Schakel de handmatige brandstofpomp in
1 (D5/3.3) totdat uit de verluchtingsklep
2 (D5/3.3) brandstof zonder luchtbellen
stroomt. Onderbreek de werking van de
pomp.
- Sluit de verluchtingsklep 2 (D5/3.3).
- Sluit de dop van de brandstoftank.
- Start de motor. Het toevoersysteem voert
automatisch de verluchting uit.
Onderbreek na het inschakelen van de
motor de werking van de handmatige
brandstofpomp. Anders kan de handmatige
pomp beschadigd raken.
1
2
3