Download Print deze pagina

Manitou MRT 2150 Privilege Plus ST4 S2 Handleiding pagina 213

Duma rent
Verberg thumbnails Zie ook voor MRT 2150 Privilege Plus ST4 S2:

Advertenties

IT
B17 -
Pulire il filtro di ventilazione
esterno della cabina (optional
climatizzazione)
- Smontare il carter di protezione.
- Estrarre il filtro di ventilazione cabina "1"
(fig.B17).
- Pulire il filtro con un getto d'aria
compressa.
- Controllare lo stato del filtro e sostituirlo
se necessario (vedi: 3 - MANUTENZIONE:
ELEMENTI FILTRANTI E CINGHIE).
- Rimettere il filtro.
- Rimontare il carter di protezione.
B18 - Svuotamento del pre-filtro carburante
con separatore di acqua (se necessario)
Il carburante versato su superfici bollenti o
componenti elettriche può provocare incendi.
Per evitare possibili infortuni spegnere
l'interruttore di avviamento quando si
cambiano i filtri o l'elemento separatore
dell'acqua. Rimuovere immediatamente il
carburante versato.
Accertarsi che il motore sia fermo prima
di
eseguire
qualunque
operazione
manutenzione o riparazione.
Il separatore dell'acqua è in depressione
durante il funzionamento normale del
motore. Accertarsi che la valvola di scarico
sia chiusa bene, per prevenire l'entrata di aria
nell'impianto di alimentazione.
Pulire accuratamente l'esterno del prefiltro
nonché il suo supporto per impedire la
penetrazione della polvere nel sistema.
- Aprire il cofano motore
- Collocare un contenitore adatto sotto
il separatore dell'acqua per raccogliere
qualsiasi fluido che potrebbe fuoriuscire.
Ripulire qualsiasi fluido eventualmente
fuoriuscito.
- Assicurarsi che il corpo esterno del gruppo
del filtro sia pulito e privo di sporco.
- Installare un tubo adatto sullo scarico "3"
(fig. B18). Aprire la valvola di scarico "2"
(fig. B18). Ruotare la valvola di scarico in
senso antiorario. Sono necessari due giri
completi. Allentare la vite di sfiato "1"
(fig. B18).
- Lasciare che il liquido defluisca nel
contenitore.
- Inserire le filettature della valvola
nell'elemento filtrante e serrare la valvola
di scarico solo con le mani. Serrare
saldamente la vite di sfiato.
- Rimuovere il tubo e il contenitore.
1
EN
B17 -
Clean the cab external ventilation
filter (optional air conditioning)
- Remove the guard.
- Remove the cab ventilation filter "1" (Fig.
B17).
Clean the filter with a jet of compressed air.
- Check the condition of the filter and repla-
ce it, if necessary (see: 3 - MAINTENANCE:
FILTER ELEMENTS AND BELTS).
- Refit the filter.
- Refit the guard.
B18 - Emptying the fuel pre-filter with
water separator (if necessary)
The fuel poured on the boiling surfaces
and electrical components can cause fires.
To avoid possible accidents, switch off the
starter switch while changing the filters or
water separator element. Remove spilt fuel
immediately.
di
Make sure the engine is stationary before car-
rying out any maintenance or repairs on it.
The water separator is in underpressure
during the normal working of the engine.
Make sure the discharge valve is closed pro-
perly to prevent air from entering the supply
system.
Wipe the outside of the prefilter as well as
its support thoroughly to prevent dust from
penetrating the system.
- Open the engine hood.
- Place a suitable container under the
condensate trap to collect the fuel that
flows out. Wipe fluid that may have leaked
outside.
- Make sure the outer body of the filter unit
is clean and devoid of dirt.
- Install a suitable tube on outlet "3" (Fig.
B18). Open discharge valve "2" (Fig. B18).
Turn the discharge valve anticlockwise.
It must be turned through two complete
turns. Slacken the venting screw "1" (Fig.
B18).
- Let the liquid flow out into the container.
- Insert the valve thread in the filter ele-
ment and tighten the discharge valve only
manually. Tighten the vent screw firmly.
- Remove the tube and container.
B17
www.duma-rent.com
B17 -
- Demonteer het beschermingscarter.
- Verwijder de ventilatiefilter cabine "1"
(Fig.B17).
- Blaas de filter schoon met behulp van een
straal samengeperste lucht.
- De staat van de filter controleren en hem
zo nodig vervangen (zie: 3 - ONDERHOUD:
FILTERELEMENTEN EN DRIJFRIEMEN).
- Plaats de filter terug.
- Breng het beschermingscarter weer op zijn plaats.
B18
Wanneer brandstof op kokende oppervlakken
of elektrische onderdelen wordt gegoten,
kan dit brand veroorzaken. Om mogelijke
ongevallen
startschakelaar uit wanneer u filters of
het waterafscheidingselement vervangt.
Verwijder onmiddellijk de gemorste brandstof.
Verzeker
stopgezet is voordat u onderhouds- of
herstellingswerkzaamheden verricht.
Tijdens de normale werking van de motor
bevindt de waterafscheider zich in onderdruk.
Verzeker u ervan dat de afvoerklep goed
gesloten is, om te voorkomen dat er lucht in
het toevoersysteem terechtkomt.
Maak de buitenkant van de voorfilter
zorgvuldig schoon, evenals zijn steun om
te voorkomen dat stof in het systeem kan
binnendringen.
- Open de motorkap
-
Plaats
waterafscheider die geschikt is om
lekkende vloeistoffen op te vangen.
Verwijder vloeistoffen die eventueel
gemorst zijn.
- Verzeker u ervan dat de behuizing van de
filtergroep schoon is.
- Installeer een geschikte leiding op de
afvoer "3" (Fig.B18). Open de afvoerklep
"2" (Fig.B18). Draai de afvoerklep linksom.
U dient twee volledige draaibewegingen
uit te voeren. Draai de afvoerschroef "1"
los (Fig.B18).
- Laat de vloeistof in het opvangbakje
stromen.
- Steek het schroefgedeelte van de klep in
het filterelement en draai de afvoerklep
alleen met de handen vast. Draai de
afvoerschroef stevig vast.
- Verwijder de buis en het opvangbakje.
B18
3-32
NL
De externe ventilatiefilter van de
cabine schoonmaken (optional
airconditioning)
-
De
brandstofvoorfilter
met
waterafscheider leegmaken (indien
nodig)
te
vermijden,
schakel
u
ervan
dat
de
motor
een
opvangbak
onder
1
2
de
de

Advertenties

loading

Deze handleiding is ook geschikt voor:

Mrt 2550 privilege plus st4 s2