Advertenties
Inhoudsopgave
31 Programmeerbare tastcycli.................................................................................................... 1625
31.1 Met tastcycli werken.................................................................................................................. 1626
31.1.1
Algemene informatie over de tastcycli............................................................................................ 1626
31.1.2
Voordat u met tastcycli gaat werken!.............................................................................................. 1632
31.1.3
Programma-instellingen voor cycli.................................................................................................... 1634
31.2 Tastcycli scheve ligging van werkstuk automatisch bepalen...................................................... 1636
31.2.1
Overzicht................................................................................................................................................. 1636
31.2.2
Basisprincipes van de tastcycli 14xx................................................................................................ 1638
31.2.3
Cyclus 1420 TASTEN VLAK............................................................................................................... 1648
31.2.4
Cyclus 1410 TASTEN KANT............................................................................................................... 1654
31.2.5
Cyclus 1411 TASTEN TWEE CIRKELS............................................................................................. 1661
31.2.6
Cyclus 1412 TASTEN SCHUINE ZIJDE............................................................................................ 1669
31.2.7
Cyclus 1416 TASTEN SNIJPUNT...................................................................................................... 1677
31.2.8
Basisprincipes van de tastcycli 4xx.................................................................................................. 1684
31.2.9
Cyclus 400 BASISROTATIE................................................................................................................. 1685
31.2.10 Cyclus 401 ROT 2 BORINGEN........................................................................................................... 1689
31.2.11 Cyclus 402 ROT 2 TAPPEN................................................................................................................ 1694
31.2.12 Cyclus 403 ROT OVER ROTATIE-AS................................................................................................. 1699
31.2.13 Cyclus 405 ROT OVER C-AS.............................................................................................................. 1705
31.2.14 Cyclus 404 BASISROTATIE BEPALEN.............................................................................................. 1710
31.2.15 Voorbeeld: basisrotatie via twee boringen bepalen....................................................................... 1711
HEIDENHAIN | TNC7 | Gebruikershandboek Volledige uitgave | 10/2022
43
Advertenties
