Advertenties
Fault
No camera signal
Too far away
Too close to the ma-
gnetic tape
Wi-Fi symbol:
Fault
WLAN symbol with
line through it
The WLAN signal is
weak
GNSS symbol:
Fault
GNSS symbol with
line through it
No GPS data
The GNSS symbol
is blinking
The GNSS symbol
is oscillating
Anl_FREELEXO_CAM_PLUS_SPK13.indb 62
Anl_FREELEXO_CAM_PLUS_SPK13.indb 62
GB
Possible cause
The robot lawn mower does
not receive a signal from the
camera unit
The robot lawn mower is too far
away from the charging station
(19)
The lawn mower detects a ma-
gnetic tape signal in the imme-
diate vicinity
Possible cause
The robot lawn mower is not
receiving a WLAN signal
The robot lawn mower res-
ponds with great delay or does
not respond at all.
Possible cause
The robot lawn mower is not
receiving a GNSS signal
The GNSS signal is not precise
The robot lawn mower is se-
arching for a GNSS connection
and is calibrating the position of
the charging station.
- 62 -
Remedy
Switch off the main switch (OFF) and then
switch it back on again (ON) to restart the
robot lawn mower.
Move the robot lawn mower into the mowing
area which is near the charging station
Switch off the main switch (OFF) and then
switch it back on again (ON) to restart the
robot lawn mower.
For starting purposes, the robot lawn mower
must be a minimum of 1m from the magnetic
tape.
Remedy
- Restart the robot lawn mower
- Check the WLAN connection
- If necessary, reset the WLAN connection.
Check the WLAN cover in your garden.
Remedy
Make sure that the robot lawn mower is out-
side and that the GNSS signal is not being
blocked
If the GNSS signal blinks permanently, the
received signal is very weak (blocked by a
building or tree) and the position of the char-
ging station should be adapted.
Wait for the calibration to be completed.
04.10.2024 10:05:51
04.10.2024 10:05:51
Advertenties
