Fault
PCB overheated
Rain
Sensor fault (guide
cable sensor, dis-
tance sensor, mag-
net sensor)
Motor fault/
motor overcurrent
Operating fault:
Poor boundary
Anl_FREELEXO_CAM_PLUS_SPK13.indb 61
Anl_FREELEXO_CAM_PLUS_SPK13.indb 61
GB
Possible cause
The temperature of the rechar-
geable battery is too high/low
or the controller is overheated
- If the battery temperature
exceeds 65 °C, the robot
lawn mower will return to the
charging station (19).
- If the battery temperature ex-
ceeds 45°C or drops below
0°C, charging will be stopped
and the robot lawn mower
will wait at the charging stati-
on (19).
- The rain sensor (5) has trip-
ped.
- The robot lawn mower was
stopped due to a sensor fault
- The robot lawn mower has
come to a stop because of
overcurrent in the motor or
because of a motor fault
- The robot lawn mower was
stopped due to an operating
fault
The robot lawn mower is situ-
ated in the charging station or
within the search loop, and the
deviation from the reference
quality value has greatly wor-
sened.
- 61 -
Remedy
- Set the work time in summer to the early
hours of morning and avoid running the
robot lawn mower during the hours of the
day when it is hot.
- After the battery or controller has cooled
down to the permissible temperature ran-
ge, the robot lawn mower automatically
returns to programmed operation.
- Wait until the robot lawn mower is dry.
- A detailed description of the sensor can
be found in section 5.2.
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
- Check the height of the grass in the
mowing area and, if necessary, mow the
grass to below 60 mm using a conventio-
nal lawn mower.
- Increase the cutting height. Always start
with a higher cutting height and reduce it
in small steps until you reach the desired
height.
- Inspect the blade plates (11) and wheels
for dirt and give these parts a thorough
clean.
- Check the rear wheels and the blade plate
(11) for blockages. If you are unable to
remove the blockages, contact the res-
ponsible customer service center.
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
Check the boundaries of the mowing area.
Then delete the reference value and carry
out a new initialization of the boundary qua-
lity value.
04.10.2024 10:05:51
04.10.2024 10:05:51