Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
9.
Setting up the Transmitter
In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Aligning the Transmitter Aerial
Angle the transmitter's aerial (see figure 1, item 1) to the side, so that the aerial is at a 90° angle to the connection line
remote control/model. This is how you will achieve best signal transmission.
Do not point the tip of the transmitter aerial at the model, this strongly reduces range.
When the receiver aerial is attached vertically in the model, align the transmitter aerial vertically up as well.
b) Inserting the Batteries/Rechargeable Batteries
For the power supply of the transmitter you will need 8 alkaline batteries (e.g. Conrad item no. 652507, pack of 4,
order 2) or rechargeable batteries mignon size (AA). For ecological and economical reasons it is recommended to use
rechargeable batteries, since they can be recharged in the transmitter through the built-in charging socket.
Proceed as follows to insert the batteries or rechargeable batteries:
The battery compartment lid (1) is located on the back of
the transmitter. Press the corrugated area (2) and push
off the lid downwards.
Now insert 8 batteries or rechargeable batteries in the
battery compartment. Always make sure the polarity of
the batteries is correct. A corresponding note (3) is loca-
ted on the bottom of the battery compartment.
Then out the cover of the battery compartment back on
and let it snap into place.
Figure 3
64
Advertenties
