Inhoudsopgave
Advertenties
Operation
Adjustment of Stacking Platform
Step 1 - Checking the spring adjustment
Load a stack of 15 to 20 items on to the stacking platform to test the dispensing height.
Wait for a reaction.
If the dispensing height of the crockery stack is about 0.8'' (2 cm) above the upper edge of the appliance, the
spring system is adjusted correctly.
If the stack drops down only a little or not at all, the dispensing height must be altered by adjusting the
springs.
Step 2 - Altering the spring adjustment
The dispensing height is adjusted by hooking or unhooking tension springs on two attachment bars. The
springs are arranged in groups of 9, where 8 are base springs with higher tension (1) and 1 is an adjustable
spring (2) with lower tension.
Figure 6
If the dispensing height is too high, adjustable springs must be unhooked.
If the dispensing height is too low, adjustable springs must be added.
Procedure:
Take out the inserted crockery items (if available).
Take out the inserted guide rails (if available).
Lift the stacking platform uniformly and place it down on the appliance. Finally, grip the stacking plat-
form with both hands and put it down in a suitable place.
Hook or unhook adjustable springs uniformly in all groups of springs.
Preferably unhook the adjustable springs. Always leave the base springs inserted, if possible. Always
unhook the springs on the lower attachment bar.
Finally, insert the stacking platform back with the basket opening facing downwards. If the stacking
platform is inserted correctly, the guide rollers must face the interior of the appliance, as otherwise the
crockery can become dirty.
Both steps must be repeated as often as possible, until the dispensing height is in the range from 0.6 to 1''
(1,5 to 2,5 cm). So long as the same kind of crockery is always used, the dispensing height only needs to be
set once.
ATTENTION
NOTE
4330005_A0
Attachment bar with tension springs
Risk of fire
If the stacking platform is inserted with the basket opening facing upwards,
this will cause in heated appliances thermally-induced damages to the plastic-
coated rods and the risk of fire.
Only insert the stacking platform with the basket opening facing downwards.
Arrangement of the springs
A symmetrical arrangement of springs between the attachment bars is neces-
sary for guiding the stacking platform uniformly and without friction.
A slightly asymmetrical arrangement of springs within an attachment bar does
not pose any problem.
UST/57-28 | UST/57-28K | USTH/57-28 | USTUH/57-28 | EUSTH/57-28
Chapter 5
Page 21
Universal Crockery Dispenser
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
