Inhoudsopgave
Advertenties
Chapter 5
Page 20
5
Operation
5.1
Arrangement and Function of the Operating Elements
The operating elements are fitted on the front of the housing of the heated universal crockery dispenser.
Figure 5
The desired temperature can be set on the thermostat. A continuous adjustment is possible within the 4
power ranges. The On / Off switch of the appliance is arranged next to it. An indicator light integrated into the
switch shows, whether the appliance is ready to be operated.
5.2
Adjustment of Stacking Platform
WARNING
The adjustments of the stacking platform should only be carried out on the appliances, which are switched
off, disconnected from the power supply and cooled down (room temperature).
Basically, the appliance must be adjusted if at least one of the following crockery parameters alters: diameter
or edge length, height, stack height and weight.
5.2.1
Spring adjustment
ATTENTION
Before loading the appliance, the dispensing height must be adjusted to the kind of crockery used. The dis-
pensing height is adjusted by hooking or unhooking tension springs.
The dispensing height must be adjusted so that over the entire lift the uppermost item of crockery is con-
stantly moved upwards to a uniform dispensing height between 0.6 and 1'' (1,5 and 2,5 cm) above the upper
edge of the housing.
Universal Crockery Dispenser
UST/57-28 | UST/57-28K | USTH/57-28 | USTUH/57-28 | EUSTH/57-28
Operating elements of USTH/57-28 and USTUH/57-28
Risk of hot surfaces
The internal surfaces of the heated appliances and the base plates can be-
come hot during operation and only cool down slowly in the air.
To adjust the stacking platform, allow the appliance to cool down sufficiently
with the cover removed.
Damage to persons and property due to improper adjustment
When the dispensing height is exceeded, there is a risk of accident or injury
due to tipping of the crockery stack and breakage of dishes. If the level falls
below the dispensing height, injuries to the fingers due to squashing can oc-
cur when removing dishes.
Be careful when taking the stacking platform out and putting it back in. If it is
handled incorrectly, there is a risk of crushing your fingers.
Adjust appropriately the dispensing height by hooking or unhooking the
springs.
When adjusting springs on sharp edges, pay particular attention to the ends of
the tension springs. Act carefully.
Arrangement and Function of the Operating Elements
Operation
4330005_A0
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
