Inhoudsopgave
Advertenties
Chapter 4
Page 18
There is a connecting cable set with a wiring diagram attached to the built-in appliance. The set consists of
an on-site connecting cable with a Schuko® plug and a connecting cable with an appliance plug. The con-
necting cables are wired up with the on/off switch with an integrated indicator light.
4 threaded covers for the screw feet of EUSTH/57-28 are also attached.
Step 1 - Preparation
Prepare cut-outs in the worktop and the front cladding corresponding to the indicated dimensions.
The cut-out dimensions for a worktop and a switch are given in mm as shown in the drawing.
Remove the protective plastic film from the metal plates of EUSTH/57-28.
Step 2 - Assembly
NOTE
Adjust the height-adjustable screw feet so that the appliance can be positioned under the worktop.
Position the appliance exactly under the cut-out in the counter and adjust the screw feet.
Fasten the stacking compartment in the worktop cut-out using 4 angled guides.
Figure 4
Universal Crockery Dispenser
UST/57-28 | UST/57-28K | USTH/57-28 | USTUH/57-28 | EUSTH/57-28
Transport, Assembly, Putting into Operation and Decommissioning
Presetting the operating temperature
In contrast to the mobile appliances with the switch and controller arranged
next to each other, the switch of the built-in appliance can be placed any-
where on the front side.
Under these circumstances, the controller is no longer accessible for operat-
ing after the installation. Ensure that the desired temperature is set on the
thermostat before the installation.
Assembly instructions EUSTH/57-28
Assembly (EUSTH/57-28 only)
4330005_A0
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
