Advertenties
Beschikbare talen
Beschikbare talen
9.4
MEANING OF THE INDIVIDUAL PARAMETERS
9.4.1 USER MENU
From the main menu, pressing the MODE key (or using the selection menu and pressing "+" oR "-"), gives access to the USER
MENU. In this menu, the following values are displayed in sequence.
VP: Pressure display
Plant pressure measured in [bar] or [psi] depending on the measuring system used, or level of the liquid in the tank. Available only if
the pressure or depth sensor is used.
C1: Display of the phase current of pump P1
Phase pump of the electropump connected as P1 in [A].
C2: Display of the phase current of pump P2
Phase pump of the electropump connected as P2 in [A].
PO1: Display of the power absorbed by pump P1
Power delivered to the electropump P1 in [kW].
PO2: Display of the power absorbed by pump P2
Power delivered to the electropump P2 in [kW].
VE: System monitor
Displays the system status, the hardware and software release of the Ebox can be displayed.
SN: Serial
Displays the serial number assigned to the panel by the DConnect Box.
9.4.2 MONITOR MENU
From the main menu, by holding down simultaneously for 2 sec the keys "SET" and "-", or using the selection menu and pressing "+"
or "-", you can access the MONITOR MENU.
In this menu, by pressing the MODE key, the following values are displayed in sequence.
FF: Fault log display
Chronological display of the faults that have occurred during system operation.
For each fault the following are displayed:
A symbol for the area concerned: the panel, pump P1 or pump P2.
•
The type of error or alarm, summed up in a code. See Table 19).
•
The number of times the error has occurred.
•
A text description of the error or alarm.
•
The time of switching on the panel or of pump operation at which the error occurred.
•
The order of the error in the log and the number of errors in the memory.
The faults are displayed in chronological order starting from the oldest one. The last one that occurred is shown first. The maximum
number of faults that can be displayed is 64; if the number of errors is greater, the oldest ones are overwritten.
CT: Display contrast
Adjusts the display contrast.
LA: Language
Changes the language used on the display. Attention, Kiwa mode is present only if the language is Dutch, French or English UK and
US.
Note: If US is selected, the Ebox will use English with Imperial measurements.
HS: System operating hours
Indicates the hours the system has been on.
H1: Pump P1 operating hours
Indicates the hours the pump P1 has been on.
H2: Pump P2 operating hours
Indicates the hours the pump P2 has been on.
9.4.3 SETPOINT MENU
From the main menu, hold down simultaneously the "MODE" and "SET" keys until "SETPOINT MENU" appears on the display (or use
the selection menu pressing "+" or "-"). In this menu the parameters displayed depend on the type of application.
ENGLISH
Figure 59: Errors in the memory
102
Advertenties
