Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
We recommend recharging your Luminette® when there is only one LED
remaining when you turn the device off.
Attention:
The battery life detector only works correctly if the Luminette® has been
completely charged. We recommend that you charge the Luminette fully every time.
F. Switching on and off
Attention: before your first use, be sure you take off the protective film over the
hologram.
Ensure that the battery is charged so that your Luminette® will work for the entire
session chosen. Press the Start-Stop button briefly to turn your Luminette® on
(see figure 1).
To change the intensity of the light, just press the Start-Stop button briefly. The
intensity will change in a cycle: level 1, then level 2, level 3, and back to level 1, etc.
To turn off your Luminette®, hold down the On-Off button (for 2 seconds).
G. How to wear your Luminette®
For the best results, you need to wear your Luminette® correctly.
To properly position your Luminette®:
•
Set the nosepiece into one of the three slots (see figure 1). A "click" sound
means that your nosepiece is correctly inserted.
•
Place the padded part of the nosepiece where your nose and forehead
meet. The lower edge of the holographic visor should be located just above
your line of sight (see figure 2) when you look into a mirror.
Please note that if you wear glasses, the nose bracket of the Luminette® should
be behind your glasses (see figure 3).
Once the session has begun, keep your eyes open. Carry on with whatever you
are doing. Do not look directly into the LEDs.
H. How to look after your Luminette®
This device is meant exclusively for personal use. Between each use, store the
device in its protective case in a dry place.
EN
15
Advertenties
Inhoudsopgave
