Advertenties
Beschikbare talen
Beschikbare talen
The following features can be adjusted:
Various features depending on the selected battery type (LiPo, LiIo, LiFe, LIHV, NiMH, NiCd, Pb) can be
adjusted. For example, only lithium batteries have the feature to configure the end charge voltage per cell.
That is why you should always set the battery type first and then the remaining data, so that the charger can
provide the appropriate setting options.
Battery type
BATT TYPE
LiPo
Select the battery type "LiPo", "LiIo", "LiFe", "LIHV", "NiMH", "NiCd" or "Pb" here.
As already described above, do this selection first, since only then will the matching setup features be shown.
Battery voltage
BATT VOLTS
7.4V(2S)
Depending on the battery type selected, you can set the battery voltage here.
However, you cannot just set any voltage. Rather, the step range depends on the rated voltage of a single
cell of the respective battery type; see Chapter 7.
For example, the rated voltage of a cell in a LiPo battery is 3.7 V; you can thus configure the battery voltage
only in steps of 3.7 V (3.7 V, 7.4 V, 11.1 V, etc.).
Charging current
CHARGE CURRENT
2.2A
Set the desired charging current (0.1 - 40.0 A) here. This must be selected in accordance with the battery used.
Note that the charging power of the charger is up to 1000 W. The maximum charging current may thus not be
available for batteries with multiple cells.
Discharging current
DSCH CURRENT
1.2A
Set the desired discharging current (0.1 - 8.0 A) here. This must be selected in accordance with the battery used.
Note that the discharging power of the charger is max. 80 W. The maximum discharging current may thus not
be available for batteries with multiple cells.
All manuals and user guides at all-guides.com
81
Advertenties
