3 3
2.
14
D
Vor Inbetriebnahme
Maschine abstellen
BEACHTEN! Den Schwadkreisel
nur auf festem und ebenen Boden
abstellen.
• Stützfuß (1) nach unten auszie-
2 2
hen und mit Stecker (2) sichern
(Abb. 25).
• Maschine auf den Boden ablas-
sen.
• Bei abgehängtem Schwader alle
Stecker und Schnell kupplungen
in die dafür vorgesehenen Halter
an der Deichsel einstecken.
25
BEACHTEN! Hydraulik -
Druckluftschläuche so ablegen,
daß
die
nicht verschmutzt werden.
• Hydraulikhahn (3) an den hin-
teren Kreiseln schließen (Abb.
26).
• Die Gelenkwelle am Schlepper
abnehmen und mit der Kette an
der Deichsel aufhängen.
• Schwader mit Druckluftbremse:
Feststellbremse anziehen.
• Schwader mit Druckluft bremse:
Zuerst den roten, dann den gel-
ben Kupplungskopf ab kuppeln.
26
Schwader
be tätigter Bremse:
Den Hydraulikschlauch für die
hydraulisch betätigte Bremse
von der Schnellkupplung am
Schlepper abnehmen.
• Unterlenker aushängen.
• Bedienpult vom Schlepper neh-
men.
• Wird die Maschine mit hoch-
geschwenkten Kreiselkörpern
ab ge stellt, dann müssen auf die
nach außen stehenden Feder-
zinken die Schutzleisten (6)
aufgesteckt werden (Abb. 27).
27
BEACHTEN!
Feuchtigkeit schützen!
und
Schnell kupplungen
mit
hydraulisch
Bedienpult
vor
GB
Before Operation
Storing the Machine
NOTE! Park the machine only on
solid and flat ground.
• Slide prop stand (1) to the bot-
tom and secure with pin (2) (fig.
25).
• Lower the machine onto the
ground.
• When the swather is unhitched
from the tractor, fit all plugs and
quick-release couplings to the
bracket provided for this on the
drawbar.
ATTENTION! Stow the hydrau-
lic hoses and the compressed
air hoses in such a way that
the quick-release couplings are
well protected from dirt.
• Close the shut-off tap (3) of the
rear rotors (fig. 26).
• Disconnect the PTO shaft from
the tractor and secure it to
the drawbar using the provided
chain.
• Swathers with air brake sys-
tem:
Apply the parking brake.
• Swathers with air brake sys-
tem: First disconnect the red
coupling and then the yellow
one.
Swathers with hydraulically
operated brake system:
Disconnect the hydraulic hose
for the hydraulically operated
brake system from the respec-
tive quick-release coupling on
the tractor.
• Detach the lower links.
• Remove control panel from the
tractor.
• If the machine is stored with
the rotors folded up, all tines
directed to the outside must be
covered with the safety bars (6)
(fig. 27).
ATTENTION!
Protect
panel from moisture.
EUROTOP 1251
control