respectively the ault displayed and the total number of faults present; to the right of these numbers is an indication of the type of fault displayed.

The ˄ and ˅ keys scroll through the list of faults: pressing the ˅ key goes back through the log and stops at the oldest fault present, pressing the

˄ key goes forward in the log and stops at the most recent fault. The faults are displayed in chronological order starting from the one that appeared

farthest back in time x=1 to the most recent x=y. The maximum number of faults that can be shown is 64; when that number is reached, the log

starts to overwrite the oldest ones. This item on the menu displays the list of faults, but does not allow reset. Reset can be carried out only with

the dedicated control from item RF on the TECHNICAL ASSISTANCE MENU. The fault log cannot be deleted with a manual reset, by switching

off the appliance, or by resetting the factory values, unless the procedure described above has been followed.

5.2 - Monitor Menu

From the main menu, by holding down simultaneously for 2 sec the keys "SET" and "˅" (minus), or using the selection menu and pressing ˄ or

˅, you can access the MONITOR MENU. In this menu, by pressing the MODE key, the following values are displayed in sequence.

5.2.1 - CT: Display contrast

Parameter not available on pumps with firmware version 3.xx. Adjusts the display contrast.

5.2.2 - BK: Display brightness

Adjusts the backlighting of the display on a scale from 0 to 100.

5.2.3 - TK: Backlight switch-on time

Sets the time that the backlight is lit since the last time a key was pressed. Values allowed: 20 sec to 10 min or always on (even if this option is

selected, the screen will still go into standby mode after a few hours of inactivity to safeguard the integrity of the device). When the backlight is

off, the first time any key is pressed has the sole effect of restoring the backlighting.

5.2.4 - LA: Language

Display in one of the following languages:

• Italian

• English

• French

• German

5.2.5 - TE: Dissipator temperature display

5.3 - Setpoint Menu

From the main menu, hold down simultaneously the "MODE" and "SET" keys until "SP" appears on the display (or use the selection menu pressing

˄ or ˅). The ˄ and ˅ keys allow you respectively to increase and decrease the plant boosting pressure.

Press SET to leave this menu and return to the main menu. The range of adjustment is 1-5.5 bar (14-80 psi).

Applicable to firmware versions ≤ 4.x.x

(2)

(3)

Applicable to firmware releases ≥ 4.3.x with integrated connectivity

(4)

Applicable to firmware releases ≥ 4.4.x with integrated connectivity and Multiple Groups functions

(2)

(3) (4)

• Spanish

• Dutch

• Swedish

• Turkish

ENGLISH

Figure 17.2: Power histogram display

• Slovak

• Romanian

• Russian

• Thai

(3) (4)

• Portoguese

(3) (4)

• Polish

(3) (4)

• Chinese

(3) (4)

• Czech

(3) (4)

Advertenties

DAB esybox mini3 Instructies Voor Installatie En Onderhoud pagina 58

Beschikbare talen

Gerelateerde Handleidingen voor DAB esybox mini3

Gerelateerde Producten voor DAB esybox mini3