Advertenties
NC-foutmeldingen | Lijst met NC-foutmeldingen
Foutnummer
160-0129
160-012A
160-012B
160-012C
160-012D
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Beschrijving
Error message
M112 en M113 worden niet met deze NC-software onder-
steund
Cause of error
The M115 and M113 functions are not available with this NC
software.
Error correction
Use Cycle 32 TOLERANCE in order to influence accuracy,
surface quality and machining speed.
Error message
M114 en M115 worden niet met deze NC-software onder-
steund
Cause of error
M114 und M115 are not supported by this NC software.
Error correction
- Use M144/145 or M128/129 in order to take the positions
of rotary and tilting axes into consideration.
Error message
M124 wordt niet met deze NC-software ondersteund
Cause of error
M124 is not supported by this NC software. The contour
filter cannot be programmed in the NC program.
Error correction
- Use CfgStretchFilter to configure the contour filter in the
machine configuration.
Error message
M132 wordt niet met deze NC-software ondersteund
Cause of error
M132 is not supported by this NC software.
Error correction
- Use Cycle 32 TOLERANCE in order to influence accuracy,
surface quality and machining speed.
Error message
M134 en M135 worden niet met deze NC-software onder-
steund
Cause of error
This NC software does not support M134 and M135 for a
precision stop at non-tangential transitions for positioning
moves with rotary axes.
Error correction
- Use machine-specific funtions to activate or deactivate
automatic clamping.
- If required, contact your machine tool builder
41
2257
Advertenties
