Advertenties
41
Foutnummer
230-046E
230-046F
230-0470
230-0471
2500
Beschrijving
Error message
Meerdere ingangen voor asgroepvrijgave %2 gedefinieerd
Cause of error
- Per axis group, only one PLC input for the axis-group relea-
se was defined.
- In the IOC file, multiple PLC inputs for the axis-group relea-
se were defined for one axis group.
Error correction
- Check the IO configuration.
- Inform your service agency
Error message
Ingang voor asgroepvrijgave %2 op niet-toegestaan bussys-
teem
Cause of error
The input for the axis-group release was defined on an illegal
bus system in the IO configuration (IOC file).
The input can be defined only on an HSCI-PL or an internal
PL.
Error correction
- Check the IO configuration.
- Inform your service agency
Error message
Snelle ingang voor spil verkeerd geparametriseerd
Cause of error
The fast input for the spindle was not in the IO configuration
(IOC file) or it has incorrect parameters.
Error correction
- Check the IO configuration.
- Inform your service agency
Error message
Meerdere snelle ingangen voor spil %2 gedefinieerd
Cause of error
More than one fast input was defined for a spindle in the IO
configuration (IOC file).
Only one input is allowed.
Error correction
- Check the IO configuration.
- Inform your service agency
NC-foutmeldingen | Lijst met NC-foutmeldingen
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Advertenties
