Advertenties
NC-foutmeldingen | Lijst met NC-foutmeldingen
Foutnummer
230-04E3
230-04E5
230-04E6
230-04E7
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Beschrijving
Error message
No complete circle was recorded
Cause of error
During evaluation of the measured data, it was found that no
complete circle was recorded.
Error correction
- Check whether the configured feed rate was achieved
- Check the configured trigger speed
Error message
Onjuiste UVR/UEC-configuratie: %2, index ongeldig: %3
Cause of error
No valid value entered for the machine parameter CfgSup-
plyModule3xx > hsciUvIndex.
Error correction
Check and correct the parameter: CfgSupplyModule3xx >
hsciUvIndex
Error message
Onjuiste UVR/UEC-configuratie: dubbele configuratie: %1 -
%2
Cause of error
The parameter CfgSupplyModule3xx > hsciUvIndex is identi-
cal in the two stated instances of CfgSupplyModule3xx. That
is not allowed.
Error correction
Check the parameter in all instances and correct as neces-
sary: CfgSupplyModule3xx > hsciUvIndex
Error message
Asverplaatsing tijdens omschakelen van het filter niet toege-
staan
Cause of error
No axis may move while the CLP filter is being switched on
or off.
The movement may also result from superimpositioning
(e.g., swing-frame grinding).
Possible causes of the filter switching:
- Switch-on or -off of TCPM (also M128 / M129)
- Tilting the working plane
Error correction
Edit the NC program.
41
2521
Advertenties
