Advertenties
NC-foutmeldingen | Lijst met NC-foutmeldingen
Foutnummer
1A0-01A1
1A0-01A3
1A0-01A4
1A0-01A5
1A0-01A6
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Beschrijving
Error message
Geen technologierecord voor contourbewerking beschikbaar
Cause of error
A Cycle 271 must be programmed before every fixed cycle
272, 273, or 274.
Error correction
- Adapt the NC program
- Program Cycle 271
Error message
Diepte-instelling te klein
Cause of error
You defined the plunging depth Q238 to be less than 0.1 mm
in Cycle 274.
Error correction
- Adapt the NC program
- Define the plunging depth Q238 to be greater than 0.1 mm
Error message
Gereedschapsradius te klein
Cause of error
The tool radius of the current tool is too small.
Error correction
Select a larger tool
Error message
Ruimgereedschap niet gedefinieerd
Cause of error
A roughing tool must be defined for each fixed cycle 273 and
274.
Error correction
- Adapt the NC program
- Call Cycle 272
- Reference a roughing tool in parameter Q438
Error message
Parameter diepte-instelling per omwenteling Q436 niet
correct gedefinieerd
Cause of error
You entered the value 0 for the infeed per revolution parame-
ter Q436.
Error correction
Check and correct the value in Q436
41
2353
Advertenties
