Advertenties
NC-foutmeldingen | Lijst met NC-foutmeldingen
Foutnummer
1A0-01AB
1A0-01AC
1A0-01AD
1A0-01AE
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Beschrijving
Error message
Spanmiddel niet toegestaan
Cause of error
Fixtures are not permitted in dressing mode.
Error correction
- Remove the entry CfgKinFixSocket from the active kinema-
tics configuration
- Inform your service agency
Error message
Configuratie niet geschikt voor bewerking van cilinderman-
tels
Cause of error
De eerste machine-as onder de tafel moet een modulo-
rondas zijn
Error correction
- Asconfiguratie controleren
- Neem contact op met de machinefabrikant
Error message
Spanmiddel wordt in "%1" genegeerd
Cause of error
The indicated kinematic model has no insertion point for
fixtures.
Error correction
- Adjust the machine configuration to include fixtures. To do
so, please contact your machine tool builder.
Please note: If you use the indicated kinematic model, the
machining operation will be executed without the desired
fixture.
Error message
Eiland direct na begrenzingsblok niet toegestaan
Cause of error
In the definition of the contours, an island (I2) is defined after
a "bounding block".
A "bounding block" must be followed by a pocket (P2).
Error correction
- Do not define a "bounding block" in Cycle 271 if a closed
pocket or stud is to be machined
- Use CONTOUR DEF to define a pocket after the "bounding
block" if an open pocket is to be machined.
- Refer to the User's Manual for more documentation
41
2355
Advertenties
