Advertenties
41
Foutnummer
230-0328
230-0329
230-032A
230-032B
2480
Beschrijving
Error message
Plug & Play (%2) omvormer gedetecteerd: %3
Cause of error
The "Plug & Play" function for automatic recognition of drive
components through the electronic ID label is active for this
axis.
An inverter was recognized that differs from the current
configuration.
Error correction
- Confirm the "Plug & Play" dialog, if the detected inverter
belongs to this combination of axis and parameter set
- Deactivate "Plug & Play", if the inverter was not correctly
recognized
- Contact your machine tool builder
Error message
Plug & Play (%2) voedingsmodule gedetecteerd: %3
Cause of error
The "Plug & Play" function for automatic recognition of drive
components through the electronic ID label is active.
An supply module was recognized that differs from the
current configuration.
Error correction
- Confirm the "Plug & Play" dialog prompt if the supply
module was correctly recognized
- Deactivate "Plug & Play", if the supply module was not
correctly recognized and check the configuration
- Contact your machine tool builder
Error message
As %1 (%2): motor %3 gedetecteerd en ingevoerd
Cause of error
The named motor was detected through plug-and-play
and entered in the axis configuration under CfgServoMo-
tor->motName.
Error correction
Error message
As %1 (%2): omvormer %3 gedetecteerd en ingevoerd
Cause of error
The named inverter was detected through plug-and-play
and entered in the axis configuration under CfgPowerSta-
ge->ampName.
Error correction
NC-foutmeldingen | Lijst met NC-foutmeldingen
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Advertenties
