Advertenties
Beschikbare talen
Beschikbare talen
Maintenance and operating instructions ZAF-2
Removing the spring-type actuator
Ensure trailer is securely chocked.
Disconnect brake linkage.
To facilitate handling, we recommend
unscrewing the overrun hitch from the
chassis and securing it in a vice.
Remove the locking washer from the driver
of the handbrake lever.
Move the handbrake lever in the operating
direction (guide the handbrake lever).
Pull down the bolt lock of the bolt attaching
the spring type actuator at the front and
remove the bolt.
Pull the spring type actuator out of the front
fastening clip.
Move the handbrake lever to the released
position.
The spring type actuator can now be removed.
Danger of accidents!
Do not dismantle the spring-type
actuator.
16
Installing the spring-type actuator
Push the spring type actuator onto the driver
of the handbrake lever.
Push on the locking washer and drive it
onto the driver using BPW assembly tool
12.102.00.010.
Pull the handbrake lever backwards until the
front spring type actuator eye lines up with
the hole in the clip.
Fit the bolt and secure it with the bolt lock.
Check the safety cable for damage and
replace it, if necessary.
Install the safety cable through the cable
guide from the rear.
17
Advertenties
