Advertenties
Beschikbare talen
Beschikbare talen
2. Operation
2.1 Connection
The HMCflex unit is attached using the supplied clamping brackets or three M6 threaded bushes in
the housing bottom. The HMCflex is electrically connected via a 19-pole D plug, Type HDP 26-24-19
SE. The standard wiring is shown below.
Low-power contacts
1
Oil pressure
2
"D+" terminal (excitation)
3
Temperature
4
Miscellaneous
5
Terminal 31, GND, earth
6
Operating solenoid, excitation wind-
ing
7
Auto/Manual feed off/Return stroke
on
(plus switching)
9
External stop/hood or cover switch
11
Feed
13
"W" terminal
15
Return stroke
17
CAN Low
19
CAN High
High-power contacts
8
50f to starter
10
19/17 pre-glowing
12
19/17 pre-glowing or Cl.15
(programmable)
14
"30" terminal, battery +
16
"30" terminal, battery +
18
Operating solenoid, pull-in winding
The HMCflex unit can be used for engine monitoring in conventional engines. For this purpose, wire
the engine parameters to be monitored according to the above diagram.
8/40
Operating Instructions
ehb wire code
green 1mm²
white 1mm²
brown 1mm²
grey 1mm²
blue 1mm²
black 1mm²
orange 1mm²
grey/red 1mm²
green/white 1mm²
green/grey 1mm²
green/black 1mm²
brown twisted pair or
shielded
white twisted pair or
shielded
Versoin 2.9.4
purple 2.5 mm²
yellow 2.5 mm²
yellow 2.5 mm² or red 2.5mm²
brown 2.5mm²
brown 2.5mm²
black 2.5mm²
© ehb Errors expected.
HMCflex
Advertenties
