Advertenties
Beschikbare talen
Beschikbare talen
4.2 [6] Chipper
Parameter
Pulses/Rev (IPU)
TopSpeed
norm. rpm
ret. rpm
Low Speed
PushTime
Percent min
-1
Chipper mode
rpm ctrl
26/40
Operating Instructions
Explanations
Enter the number of impulses per rotation from the pulse generator or the
number of pole pairs of the generator including the transmission ratio. See
also chapter 5.2 for further details.
Attention: This menu option changes the same setting as the "Imp/rot" menu
option in chapter 4.1.2 [2] Sensors and has been inserted at this point as
requested by the customer.
Setting the upper speed limit. If this value is exceeded, the feed rate is deac-
tivated.
Setting the standard speed. If this value is exceeded, the chopper automatic is
automatically activated.
Setting the return speed. If this value is exceeded, the system re-activates the
feed rate if it has been deactivated due to underspeed.
Setting the lower speed limit. If the speed falls below this value, the system
deactivates the feed and activates the return for the defined push time.
Setting the return stroke time. If the speed falls below lower limit, the system
deactivates the feed and activates the return for this defined time.
Setting the speed monitoring, as to whether the speed limit values are given
as real speed values or percentages relative to the standard speed.
Example: At a set standard speed of 1000 min
equals a speed of 900 min
Setting the Chipper automatic to OFF for manual mode or mode 1 to 3.See
also chapters Fehler! Verweisquelle konnte nicht gefunden werden. and
7.2.
Setting the start speed control.
The ON setting prevents a start at present speed. This setting is useful when
the speed signal of the generator or a pulse generator is used by the engine.
The OFF setting permits a start at present speed. This setting is useful when
the speed of the chipper blade is measured with a pulse generator. During
restart, it can happen that the decoupled chipper blade has still a significant
speed.
Versoin 2.9.4
-1
, a lower speed limit of 90%
-1
.
HMCflex
© ehb Errors expected.
Advertenties
