Advertenties
Beschikbare talen
Beschikbare talen
HMCflex
Switching on and off
Use the ignition starter switch (position 1) integrated in the controller with active terminal 30 to switch
on the HMCflex unit. You can start the engine (position 2) when the pre-glow time has elapsed. In this
manner, you directly reach the operating mode in which the speed, operating hours, oil pressure and
engine temperature (or only the "OK" state, if selected) are displayed. Use the arrow keys to switch to
display the daily and total operating hours.
Use the ignition key to switch off the engine and the HMCflex unit. The HMCflex will automatically run
on until the engine is at standstill.
In the event of a fault, HMCflex automatically shuts down the engine according to the programmed
parameters. The fault state is displayed by a red warning light and a full text on the display.
Possible fault causes are:
Programmed faults (alarms) are indicated by a flashing warning light and full text on the display. The
display toggles between fault and operating parameter display.
The device must be connected to steady plus (terminal 30) for the correct retention of data and set-
tings.
After the HMCflex has been switched on, the following screen is displayed for a short time. It provides
the installed software version.
© ehb Errors expected.
Operating Instructions
** Attention! **
error : temp.
** Attention! **
error : oilpress
** Attention! **
error : gen. D+
** Attention! **
error : lowspeed
ehb-electronics
HMCflexS0522xk2
Version 2.9.4
9/40
Advertenties
