Advertenties
Beschikbare talen
Beschikbare talen
HMCflex
3. Changing settings
If you want to change the default settings, you must program the HMCflex device after the initial set-
up. The engine must be at standstill for programming.
Open the parametrisation mode by pressing the SET key and simultaneously turn the ignition key to
the Ignition position. The system displays a menu listing the various main menus. Use the arrow keys
to navigate to the main menus and press SET to open the required menu.
Main menu structure
[1] settings
[2] service
[3] security
[4] day hours
[5] total hours
[6] Chipper
Back
All settings are directly saved and applied when the programming mode is closed. When the pro-
gramming mode is closed, HMCflex will continue to operate in basic mode. The settings are also
applied when you terminate programming by shutting down the device with the ignition starter key.
The queries in the main menus allow you three attempts to enter the correct PIN number before auto-
matically returning to the main menu overview. In the PIN number is not known, you have the option to
terminate the query with the ignition starter switch. Schematic overview – Set-up menu (example)
© ehb Errors expected.
Operating Instructions
SET
Pin No.:
1000
SET
Pin No.:
2000
SET
Pin No.:
3000
SET
Pin No.:
4000
SET
Pin No.:
5000
SET
Pin No.:
6000
Return to the selection
SET
Version 2.9.4
SET
Basic HMCflex settings, including
language, I/O functions, times,
limit values, etc.
SET
Service interval setting, service
interval confirmation, fault log
retrieval
SET
Attention! You can change the
PIN number in this menu. 0000 =
PIN query deactivated.
SET
Delete here the daily operating
hours.
SET
Set or delete the total operating
hours in this menu item.
SET
Basic setting of the
chopper functions.
11/40
Advertenties
