Advertenties
8. Using Setup Memory
Data logger setup data (Data Logger settings, sampling mode, assigned sensor, sampling
setup) is stored at the time it is created in a memory area called the "current setup memory
area". The current contents of the current setup memory area are overwritten whenever you
create other setup data.
You can use setup memory to save the current setup memory area contents to calculator
memory to keep it from being overwritten, if you want.
k Saving a Setup
1. Display the sampling screen you want to save.
2. Press 4(OTHER)2(MEMORY).
•
This displays the setup memory list.
•
The message "No Setup-MEM" will appear if there is no setup data stored in memory.
3. Press 2(SAVE).
•
This displays a setup name input screen.
4. Input up to 18 characters for the setup name and then press w.
•
This displays a memory number input dialog box.
5. Input a memory number (1 to 99) and then press w.
•
This returns to the setup memory list.
6. Press J.
•
This returns to the sampling screen.
Important!
• Since you assign both a setup name and a file number to each setup, you can assign the
same name to multiple setups, if you want.
k Using and Managing Setups in Setup Memory
All of the setups you save are shown in the setup memory list. After selecting a setup in the
list, you can use it to sample data or you can edit it.
• To preview saved setup data
You can use the following procedure to check the contents of a setup before you use it for
sampling.
1. On the sampling screen, press 4(OTHER)2(MEMORY) to display the setup memory
list.
2. Use the f and c cursor keys to highlight the name of the setup you want.
ε
-25
Using Setup Memory
Advertenties
