Troubleshooting
Table continued from last page
Symptom
A fuse blows as soon as the hob
is switched on.
Celsius°Cooking
blinking, together with set
cooking method key and
display.
Unstable connection between
cookware and hob.
Set Celsius°Cooking
method key is blinking together
with set temperature display
while using the probe.
A fuse blows as soon as the hob
is switched on.
The ceramic glass plate broke.
Error codes
Error code
Er03
E2
U400
E7
48
Possible cause
The appliance is incorrectly
connected.
key is
Celsius°Cooking
assigned to wrong cooking
zone.
Low battery of cookware or
unstable bluetooth connection.
cooking
Celsius°Cooking
removed or not in touch with the
content. Or the temperature has
fallen rapidly, e.g. due to adding
cold water.
The appliance is incorrectly
connected.
Symptom
Er03 appears on display.
E2 appears on display.
U 400 appears on display
with continuous sound
tone.
E7 appears on display
after setting up the Wi-Fi
connection.
cookware is
Probe is
Possible cause
The control panel is dirty
or has water on it.
Empty pan was heated on
the cooking zone.
Voltage of the mains is too
high.
Failed to connect to Wi-Fi
network.
Solution
Check the electrical
connections.
Remove cookware and assign
again.
Switch off the cooktop for 10
seconds and/or change the
battery.
Place Probe back or reposition
- press cooking method key if
probe isn't auto detect.
Check the electrical
connections.
Pull the plug out of the socket.
Contact your installer.
Please note! Do not throw a
broken ceramic glass plate in
the glass recycling bin but take
this to the Municipality's waste
recycling centre.
Solution
Clean the control panel.
Wait for cooking zone to
cool down or fill the pan
with foodstuff.
Connect the appliance in
accordance to rating plate
and instructions.
Try to connect the device
to your network again.
Make sure that new
devices can connect to
the network (e.g. MAC
address filtering is
disabled).