Troubleshooting; General; Troubleshooting Table - Atag IG29571SVA Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

General

NOTE!

If you notice a crack in the glass top (however small), switch off the hob immediately, unplug the

hob, and close off the gas supply.

Then contact the Service Department.

Troubleshooting table

If your hob does not work properly, it does not always mean that it is defective. Make sure to check

the points mentioned below in the table, or visit our website for more information.

Symptom

Characters appear in the

displays when the appliance is

connected for the first time.

The fan runs on for several

minutes after the hob has been

switched off.

A slight smell is noticeable the

first few times the hob is used.

You can hear a ticking sound in

your hob.

Circle of pan bottom remains

visible after cleaning.

The pans make noise while

cooking.

You have switched a cooking

zone on, but the display keeps

flashing.

A cooking zone suddenly stops

working and you hear a signal.

The hob is not working and

nothing appears in the display.

Zone stops unintended and

residual heat indicator is shown.

Possible cause

This is the standard set-up

routine.

The hob is cooling down.

The new appliance is heating

up.

This is caused by the capacity

limiter on the front and back

zones. A soft ticking sound can

also occur at lower settings.

Contaminated pan bottom used

on the cooking zone.

This is caused by the energy

flowing from the hob to the

saucepan.

The pan you are using is not

suitable for induction cooking or

has a diameter of less than

12 cm.

The preset time has ended.

There is no power supply due to

a defective cable or a faulty

connection.

Zone is overheated.