Inhoudsopgave
Advertenties
Adjustment of regular maintenance activation hour counter
N.B: Parameter visible with parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
Disabled.
from 10 to 800 hours with parameter
from 100 to 8000 hours with parameter
Maximum limit: 8000 hours (beyond this value the maintenance alarm is disabled entirely).
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
P1
P2
x4 s
• The default factory settings have now been restored.
Note:
version appears on the display, press and hold down the
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
IMPORTANT: "manoeuvre" means every motor activation (total opening or closure / partial opening / step mode, etc.).
Manoeuvres performed.
Example:
x100 = 12.300 manoeuvres.
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT: "manoeuvre" means every motor opening activation.
The message
s on / 4 s off) until system maintenance is performed and the alarm is reset.
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
until
is displayed.
If the TEST key is released,
The number of hours
is stored by the control unit, and the count is reset.
If the value
=
=
is exceeded (8000 hours of operation) the maintenance alarm is no longer managed.
Manoeuvre hours.
Example:
= 123 hours.
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on.
Example:
= 123 days.
or
.
.
.
Warning! Restoring default settings cancels all settings made previously
except for parameter
are suitable for the installation.
• Press and hold the PLUS + and MINUS - button until the unit switches on.
• The display flashes after 4 s
(UP ARROW) and
to
to
and
) is exceeded, the visual maintenance signal is activated (e.g. every
appears on the display and the alarm is not reset.
to
,
,
,
: after restore, check that all parameters
.
(DOWN ARROW) buttons for 4s.
to
.
Example:
multiplied by 100.
.
) and press TEST for 5 s. The message
.
69
Advertenties
Inhoudsopgave
