Inhoudsopgave
Advertenties
10.2
Acquisition procedure
PROG
AP P-
x4 s
x2 s
AU
AU to
to
AU to
• Press and hold PROG for 4 seconds.
• Press PROG again.
• MOTOR 1 starts opening at low speed.
• After the delay time set with parameter
•
for 2 s.
• When the message
delay set with parameter
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
•
: acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
•
: travel length error. Press TEST to clear the error, and check that both gate leaves are fully closed before
launching a new acquisition procedure.
For more information, see chapter 14 "Alarms and faults".
PROG
AU to
1 click
2
PARAM. 26
MOTORE 2
DELAY
CLOSING
TIME
is shown on the display.
is shown on the display.
(with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
(default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop is reached.
1
PARAM. 25
MOTOR 1
DELAY
OPENING
TIME
2
1
MOTORE 1
CLOSED
CLOSING
2
1
MOTORE 2
OPEN
APENING
Yes
57
Advertenties
Inhoudsopgave
