Inhoudsopgave
Advertenties
Attention: The motors of the SMARTY series with SMARTY/EMA installed must not be installed to open the door
2. Select the number of motors installed with the parameter
3. Check that the operator present function is not enabled (
OPEN
STOP
CLOSE
4. Install mechanical stops in both the open and closed positions.
5. Move the gate into the closed position. The gate leaves must be against the mechanical stops.
6. Press TEST (see TEST mode in chapter 9) and check the command signal and safety device states. If any safety
devices are not installed, jumper the relative contact or disable the device from the relative parameter ( ,
,
and
).
TEST
CLOSE
56
TEST
27
No
TEST
da
ta
No
Yes
TEST
00
. This parameter is set for two motors by default.
).
SEE CHAPTER 13 e 14
1 click
Until...
PROG
AP P-
1 click
Press and hold on
ACQUISITION
PROCEDURE
CHAP. 10.2
1 click
,
,
ACQUISITION
PROCEDURE
CHAP. 10.2
Advertenties
Inhoudsopgave
