Inhoudsopgave
Advertenties
5.2
Electrical connections
A switch or an omnipolar cut-off switch with a contact opening of at least 3 mm must be installed on the mains power
line; put the cut-off switch in OFF position and disconnect any buffer batteries before performing any cleaning or
maintenance operations.
Ensure that an adequate residual current circuit breaker with a 0.03 A threshold and a suitable overcurrent cut-out
are installed upstream the electrical installation in accordance with best practices and in compliance with applicable
legislation.
For power supply, use a H07RN-F 2G1.5 type electric cable and connect it to the terminals L (brown) and N (blue),
located inside the control panel box.
the cable with the cable retainer.
Measure the voltage on the primary mains power connection with a tester.
TRANSFORMER
For the Brushless automation system to function correctly, the mains power voltage must be:
- 230V~ ±10% for the EDGE1 control unit.
220÷230
A
V
N L
V
A
+
-COM
Connections to the electrical distribution network and to any other low-voltage conductors in the external
section to the electrical panel must be on an independent path and separate from the connections to the
command and safety devices (SELV = Safety Extra Low Voltage).
Make sure that the mains power conductors and the accessory wires (24 V) are separated.
The cables must be double insulated, strip them near the relevant connection terminals and lock them with clamps
(not supplied).
N L
SEC2 SEC1
X-Y-Z
Y
M
X
Z
Z-Y-X
Y
M
Z
X
BATTERY
- +
50
DESCRIPTION
Mains power supply 230V~ ±10% 50 Hz connection. (EDGE1/115/BOX: 115V~ ± 10%
60Hz).
Fuse 5x20 T2A.
Secondary transformer input for 26V~ motor power (SEC1) and for 19V~ power to logical
control and peripheral devices (SEC2).
N.B.: Ready wired in factory by ROGER TECHNOLOGY.
Connection to ROGER brushless MOTOR 1.
Warning! If the motor rotates in the wrong direction, simply swap any two of the three
motor connectors.
Connection to ROGER brushless MOTOR 2.
Warning! If the motor rotates in the wrong direction, simply swap any two of the three
motor connectors.
Connection to B71/BCHP (see
See instructions for B71/BCHP for further information.
Advertenties
Inhoudsopgave
