Inhoudsopgave
Advertenties
Safeguarded closure enabled.
After a period of time set with parameter
of the parameter
Safeguarded closure / opening enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period of
time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period of
time set with parameter
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Selecting limitations in battery operation
N.B.: the parameter is visible only if par.
There is no limitation for the commands when the battery voltage drops under the selected threshold. An error alert may
be activated via the COR output (if parameters
When the battery voltage drops under the threshold selected with par.
commands and does not perform closing.
When the battery voltage drops under the threshold selected with par.
automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands even if the ORO input is active and if the parameter is
When the battery voltage drops to the threshold selected with par.
automatically closes the gate and accepts only one opening command.
Battery type selection and consumption reduction
NOTE: An INCORRECT setting of this parameter, when there is no mains voltage, blocks the functions and the display
shows the message
Battery 24V
Battery 24V
Battery 36V
battery life.
Battery 36V
Selection of the battery operation management
Setting a value different than
via parameter
The control unit always accepts commands until the battery is completely exhausted.
The command becomes active when the battery voltage drops to the minimum threshold (22V
The command becomes active when the battery voltage drops to the medium threshold (23V
The command becomes active when the battery voltage drops to the maximum threshold (24V
Enabling of regular maintenance activation
N.B: Parameter visible if any password other than the default password is set (Parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT: "manoeuvre" means every motor opening activation.
The message
(1 s on / 4 s off) until system maintenance is performed and the alarm is reset.
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
is displayed.
If the TEST key is released,
The number of hours
N.B.: When 8000 hours of operation are exceeded, the maintenance alarm is disabled entirely.
Disabled.
Maintenance enabled for a period = parameter value
Maintenance enabled for a period = parameter value
68
, and then closes the gate.
.
.
is different than
(if set to
or
(2x12V
) with B71/BCHP. Acceleration/deceleration/speed reduction enabled, to increase the battery life.
(2x12V
) with B71/BCHP. No performance reduction, maximum battery consumption.
(3x12V
) with external charger. Acceleration/deceleration/speed reduction enabled, to increase the
(3x12V
) with external charger. No performance reduction, maximum battery consumption.
a battery voltage level check is activated. The desired operation type can be selected
and an error alert can be activated through the COR output via parameter
and
appears on the display and the alarm is not reset.
is stored by the control unit, and the count is reset.
=
.
and
are adequately set).
and the battery is 2x12V
) or an error alert
) is exceeded, the visual maintenance signal is activated (e.g. every
x10 hours.
x100 hours.
, the control unit
), and then the gate closes.
, the control unit accepts only opening
, after a 5 s pre-flashing, the control unit
.
the control unit, after a prelamping of 5s,
.
.
for battery 2x12V
for battery 2x12V
for battery 2x12V
÷
).
) and press TEST for 5 s. The message
)
)
)
Advertenties
Inhoudsopgave
