Advertenties
Beschikbare talen
Beschikbare talen
3. Instruction manual
3.1. To start a vehicle
1.
The tension selector must be disconnected ! **
2.
How to connect your Booster
A. Starting in 12V
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect
the blue clamp (-) to the negative (-) terminal of the battery.
B. Starting in 24V
-> Read point 3.2.: detection of 24V
If the batteries are side by side:
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect
the blue clamp (-) to the negative (-) terminal of the other battery.
If the batteries are on both sides of the vehicle:
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect
the blue clamp (-) to the mass of the vehicle.
3.
Selection of the tension
Select the tension of the vehicle to start ** -> from this moment there is current
on the clamps.
4.
Start the engine
Turn the ignition key for a maximum of 8-10 seconds, wait for a further 3 minutes
before attempting to start again.
5.
Disconnection of the tension
After starting, disconnect the tension selector.
6.
Disconnection
Disconnect the blue (-) clamp first, followed by the red (+) clamp.
7.
Storing
Return the cables and clamps to their support posts.
8.
Recharging
Recharge the Booster immediately after use !
** Important !!! -> See point 4.2. (point 5.) : Explosion risk
60
Turn OFF ignition before using the Booster.
Advertenties
