Advertenties
41
Foutnummer
280-04A1
280-04A2
280-04A3
280-04A4
2994
Beschrijving
Error message
Overdrachtsparameter bevat niet-toegestane waarde
Cause of error
A transfer parameter from an OEM macro to the cycle is not
in the permitted range.
Error correction
- Check the values transferred from the OEM macro to the
cycle
- Contact your machine manufacturer
Error message
Snijkantbreedte RCUTS te groot gedefinieerd.
Cause of error
The tooth width RCUTS is defined too large for helical or
reciprocating plunging in cycles 251 to 254.
Error correction
For helical or reciprocating plunging the tooth width must be
less than the tool radius
Correct the value for tooth width RCUTS in the tool table.
Error message
Werklengte LU van gereedschap te klein
Cause of error
The programmed machining depth is greater than the usable
length of the tool.
Error correction
Check the usable length LU in the tool table.
Correct the machining depth or use a different tool.
Error message
De gedef. afkanting is te groot.
Cause of error
The programmed chamfer is too large.
Error correction
Define a greater machining depth for the tip of the tool.
Use a tool with a larger radius.
NC-foutmeldingen | Lijst met NC-foutmeldingen
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Advertenties
