Advertenties
41
Foutnummer
280-0935
280-0936
280-0937
280-0938
280-093A
3074
Beschrijving
Error message
Spilhoek niet bekend
Cause of error
The spindle angles of the tool teeth have not been determi-
ned yet.
Error correction
- Run VTC Cycle 624
- Or enter the angles in the TNC:\table\VTC-TOOLS.TAB table
Error message
Optie voor panoramaopname ontbreekt
Cause of error
The VTC option for panorama images is not enabled
Error correction
- Consult your contact person at HEIDENHAIN
Error message
Spilnaam?
Cause of error
The spindle designation is missing or unknown.
Error correction
- Enter the spindle name in the table PLC:\VTC\VTC.TAB
Error message
Fout in VTC.TAB
Cause of error
Entries in the table PLC:\VTC\VTC.TAB are incorrect:
- An entry is missing from the feed rate fields
- Both FMAX and a numerical value were entered for a feed
rate
- An incorrect string was entered instead of FMAX
Error correction
Check VTC.TAB and enter the values correctly
Error message
Aantal snijkanten te groot
Cause of error
Het toegestane aantal snijkanten is overschreden. Er kunnen
gereedschappen met maximaal 32 snijkanten worden
opgemeten.
Error correction
NC-foutmeldingen | Lijst met NC-foutmeldingen
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Advertenties
