Advertenties
NC-foutmeldingen | Lijst met NC-foutmeldingen
Foutnummer
280-0930
280-0931
280-0932
280-0933
280-0934
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Beschrijving
Error message
Start-spilhoek ontbreekt
Cause of error
For the imaging of tools, at least the spindle angle of one
tooth must be known.
Error correction
- Run TCH PROBE Cycle 624 in order to determine the tooth
angles
- Enter the spindle angle in the VTC-TOOLS.TAB table
Error message
Max. kantelhoek overschreden
Cause of error
The maximum tilting angle of the probe contact was excee-
ded.
Error correction
Check the setup of the probe contact, and correct it if requi-
red.
The tilting angle of the probe contact must be within the
prescribed limits of both axes.
Error message
Spiltoerental niet mogelijk
Cause of error
The spindle shaft speed cannot be set for the panorama
image.
Error correction
- Please contact your machine tool builder
Error message
Spiltoerental niet mogelijk
Cause of error
The spindle shaft speed cannot be set for the breakage
control.
Error correction
- Please contact your machine tool builder
Error message
Cameragegevens niet correct
Cause of error
Incorrect internal camera data.
Caution: Collisions are possible when running the VTC
cycles!
Error correction
- Please contact HEIDENHAIN
41
3073
Advertenties
