Advertenties
NC-foutmeldingen | Lijst met NC-foutmeldingen
Foutnummer
320-0037
320-0037
320-0037
320-0037
HEIDENHAIN | TNC7 | TNCguide | 01/2022
Beschrijving
Error message
Fout in PLC-programma
Cause of error
- An error occurred when an PLC module was called in the
PLC program
- This hardware does not support the programmed analog
output at X8/X9
Error correction
- Check the PLC program and correct it
- Inform your service agency
Error message
Fout in PLC-programma
Cause of error
- Bij het oproepen van een PLC-module in het PLC-program-
ma is een fout opgetreden.
- De PL-module kon niet worden uitgevoerd
Error correction
- PLC-programma controleren en corrigeren
- Neem contact op met uw servicedienst
Error message
Fout in PLC-programma
Cause of error
- An error occurred when an PLC module was called in the
PLC program
- The transferred symbol/designator does not exist
Error correction
- Check the PLC program and correct it
- Inform your service agency
Error message
Fout in PLC-programma
Cause of error
- An error occurred when an PLC module was called in the
PLC program
- Could not create the handle
Error correction
- Check the PLC program and correct it
- Inform your service agency
41
3165
Advertenties
