Inhoudsopgave
Advertenties
SECTION 9
Fig. 9-11 0-200 Clutch Removal
6. Remove the cotter pin and washer from the pivot hook.
7. Remove the two clutch bars from the hook and the
clutch collar.
Fig. 9-12 0-200 Clutch Removal
8. Slide the clutch plate and the clutch collar off the
crankshaft.
Fig. 9-13 0-200 Clutch Removal
9-4
Clutch Disassembly (0-200)
1. Press the pulley against the front clutch plate to com-
press the spring washers.
2. Remove the Spiroloc retaining ring.
Fig. 9-14 0-200 Retaining Ring Removal
3. Lift the pulley off the front clutch hub.
4_ Remove the one plain washer and the four spring wash-
ers. Note the position of each washer as it is removed.
~
E:
F
GS
Fig. 9-15 0-200 Clutch Plate and Washp.rs
Clutch Reassembly (0-200)
1. Clean the front
cI
utch hu b.
2. Apply a thin coat of "moly" grease on the hub where
the washers and bearings go.
3. Install the spring washers as follows:
the first washer
cupped up, the second washer with the outer edges
down. Then the third washer, like the first, has the outer
edges up.
Finally, the fourth washer with outer edges
up.
Advertenties
Inhoudsopgave
