Inhoudsopgave
Advertenties
SECTION 5
5. Screw the aligning pins into the two front threaded
holes in the pump pad.
6. Install the pump by placing it carefully in position.
7. Insert the aligning pins into the front manifold holes as
the pump is lowered into place.
Fig.
5·37 Aligning Pins
8. Allow the pump bracket to rest on the steering gear
brace. Install punches through the side panel holes and
into the front bracket to hold the pump in position.
9. Install the two 5/16 inch bolts and nuts and secure the
rear pump bracket to the steering gear brace.
10. Secure the left panel to the front bracket with the bolt
and nut.
11. Connect the hydraulic tubes to the pump fittings.
12. Connect the temperature indicator wire to the sending
unit.
Fig. 5·38 Temperature Sending Unit
13. Install the two rear manifold·to·pump cap screws from
underneath. Place the 3/8 inch elastic stop nuts on top.
but do not tighten at this ti me.
14. Remove the two aligning studs and install the two front
cap screws and tighten all four cap screws evenly.
Fig. 5·39 Manifold Installed
Fig. 5·40 Control Rod Connections
15. Connect the three control rods to their respective levers.
16. I nstall the right side panel and battery supports.
Fig.5·41 Side Panel Installation
5·12
Advertenties
Inhoudsopgave
