Inhoudsopgave
Advertenties
ENGINE
CHOKE AND THROTTLE CONTROL ROUTING
AND ADJUSTMENT
B-SERIES
Choke cable is located on left side of dash panel and
parallels gas line to carburetor. See Fig. 4-1.
Adjust
choke by loosening cable retainer clamp at carburetor
end.
Set choke handle in full COLD position. Then
tighten retainer clamp to hold choke butterfly in fully
closed position.
Throttle cable is located on right side of dash panel
leading from control handle to governor. See Fig. 4·1.
Adjust throttle by loosening cable retainer clamp at
engine. Set throttle handle to full OPERATE position.
Tighten retainer clamp to hold throttle in fully open
position.
Fig.4-1 B-Series Choke and Throttle Linkage
C-SERIES
Choke cable is located on left side of dash panel. It
passes around bottom of engine through two cable clips
and into a retainer clamp at carburetor. Adjust choke by
loosening cable retainer clamp at carburetor. Set handle
in full COLD position and tighten retainer clamp to
hold choke butterfly in fully closed position. See Fig.
4-2.
C-S1 (Only)
Throttle cable is located on right side of dash panel,
leading under engine into a retainer clamp.
End of
throttle wire inserts into first hole above stop pin. See
Fig. 4-3.
Adjust throttle by loosening cable retainer
clamp. Set throttle handle to full OPERATE position.
Tighten retainer clamp with throttle in fully open posi-
tion and stop pin against bracket.
4-1
SECTION 4
Fig. 4-2 C-S1 Choke Linkage
Fig. 4-3 C-S1 Throttle Linkage
C-SERI ES (Except C-S1)
Throttle cable is located on right side of dash panel.
It passes through a cable clip on right side of engine into
throttle control bracket. See Fig. 4·4. To adjust, place
throttle in full OPERATE position.
Loosen throttle
setscrew and rotate throttle control bracket clockwise to
stop position. Tighten throttle cable setscrew.
D-SERIES
0-160
Choke cable is routed from control handle, around
battery, through retainer clip on engine to choke lever
on carburetor. Adjust choke with choke handle in the
COLD-START position. Loosen cable clamp on engine.
Tighten cable clamp to hold choke butterfly in closed
position. See Fig. 4-5.
Advertenties
Inhoudsopgave
