Inhoudsopgave
Advertenties
SECTION 7
Remove Hydraulic Cylinder
Refer to Fig. 7-1 and Fig. 7-2 during the following pro-
cedure.
Fig. 7-2 C-Series Hydraulic Lift System
1. Remove left side panel and footrest.
2. Disconnect hydraulic cylinder from lift shaft No.9.
3. Disconnect hydraulic hoses from cylinder noting hose
locations.
4. Disconnect brake pedal from brake rod.
5. Remove collar from brake pedal
shaft.
6. Slide brake pedal, spacer, washer, and cylinder off shaft.
Overhaul Hydraulic Cylinder
Refer to Fig. 7-3 during the following procedure.
1. Remove circlip No. 1 at end of hydraulic cylinder.
2.
Withdraw piston No.2 and all seals.
3. Replace
"0"
rings, gaskets, and seals with parts supplied
in rebuild kit, shown as No.3 in Fig. 7-3.
7-2
Fig. 7-3
C-Series Hydraulic Lift Components
Remove Hydraulic Valve
1. Remove left side panel exposing cylinder and four hy-
draulic hose
connections.
See Fig. 7-2. Mark two rear
hoses for identification during reassembly.
2. Disconnect 4 hydraulic hoses, two from the cylinder
and two from the pump.
3. Disconnect battery negative terminal.
4. Remove ammeter mounting panel and disconnect two
(2) connectors from ammeter. See
Fig.
7-4.
5. Remove controls cover plate.
Fig. 7-4 C-Series Hydraulic Valve Removal
Advertenties
Inhoudsopgave
