Inhoudsopgave
Advertenties
SECTION 5
5. Install a new gasket on the transaxle.
6. line the motor up on the two top case bolts and install
the nuts. Install the two lower cap screws.
Fig. 5·45 Motor Installation
7. After the motor has been secured to the transaxle, check
the seal rings to make sure they are in position.
8.
Release the back of the manifold if it was tied up during
the motor removal.
9.
Line up the manifold and install the four
(4)
bolts. Make
sure the special seal washer is under the head of the
right front bolt.
10. Connect brake rod to brake band.
11. Test the unit for proper operation.
12. Check the oil level, filling as required. Adjust the brake
band.
Fig. 5-46 Manifold Installed
Manifold Removal
1. Remove two 3/8 inch allen head screws and two 1/2 inch
cap screws holding the manifold pad to the motor.
2. Lift the manifold and remove the "0" rings.
3. Remove the two cap screws and two hex head bolts and
nuts holding the manifold to the pump.
5-14
4. Remove these "0" rings being careful to keep dirt away
from the open oil ports.
5. Remove the manifold by turning it past the steering gear
bracket and pulling it out towards rear of
tractor.
Cover all open oil ports in both motor and
pu~
keep loose dirt from entering.
---.-J
Manifold Installation
Install new seal rings on the manifold pad as follows
:
1. Place a small amount of grease in the seal ring recesses
and on the seal rings.
2.
Place a small
"0"
ring in each of the low pressure port
recesses and a large
"0"
ring in each of the high pressure
port recesses.
3. On top of each large "0" ring, place a square section
type backup ring.
Center it exactly on top of each of
the
"0"
rings.
Fig. 5-47 "0" Ring Installation
4. Place a protective cardboard cover over the seal rings to
hold them in place and keep the area free from dirt
during installation.
Fig. 5·48 Protected Seal Rings
-
--
_._
-
--- - - -
-
-
--
-
-
-
-
-
-
-
_._
--
- -
-
-
-
-
-
- -
------
-
-
Advertenties
Inhoudsopgave
