Inhoudsopgave
Advertenties
PRE-DELIVERY SERVICE
SECTION 2
B-SERIES, C-SERIES, and D-SERIES Automatic Tractors
I nstall Front Wheel and Tire Assemblies
Using a suitable hoist or jack, raise the front of the
tractor.
A. If a floor jack is used, center the jack under the frame
assembly behind the front axle. Use a 2" x 4" piece of
lumber or similar material, long enough to span the
width of the frame, between the jack and the tractor
to prevent damage to the vehicle.
B. If a chain hoist is used, attach the hoist to the front
axle, being careful not to scratch the side of the engine,
hood, or the axle itself. On C and D-Series tractors, an
alternate hoisting point can be made by installing a
piece of rod stock
(5/8"
on C-Series;
3/4"
on D-Series)
in the front Tach-a-matic hitch.
Be careful not to
scratch the grille.
Install a wheel and tire assembly on each spindle as
illustrated in Fig. 2-1, 2-2, or 2-3, as appropriate. The
tire valve stem should be to the outside on B-Series vehicles
!
and to the inside on C and D-Series vehicles.
Correct
wheel end play is 0 to .015 inch
(.4
mm). In some cases it
may be necessary to add or remove a shim washer to
, achieve correct end play.
. 015 "(Thin) Shim Washer
~~
.050"(Thick) Shim Washer
@1!lI~ O~
Snap Ring
\
CS'foaHUbCap
13t
S
·O.D. Washer
Fig. 2-1 B-Series Front Wheel Installation
~.050"(ThiCk)
Shim Washer
1!lI~~Snap
Ring
\
C@~UbCap
1
' 1 t
2 "
O. D. Washer
Fig. 2·2 C-Series Front Wheel Installation
2-'
t050"(ThiCk) Shim Washer
@
@ ...
3'h-16x~BOlt
\
~ C8~
Hub Cap
1
%"
o.
D. Washer
Fig. 2-3 D-Series Front Wheel Installation
Install Footrest (D-Series Only)
Raise the rear of the tractor (see Install Rear Wheel and
Tire Assemblies). Install the footrests as shown in Fig. 2-4.
Note that the bolt holding the rear of the mid lift bearing
must be removed to install the footrest and is replaced after
the footrest is installed.
The "L" shaped bracket is in-
stalled at the front of each footrest as shown in Fig. 2-4 .
6::'\~Bracket
~Bolts
Footrest
Fig. 2-4 D-Series Footrest Installation
Install Rear Wheel and Tire Assemblies
Raise the rear of the tractor.
A. If a floor jack is used, center the jack under the trans-
mission case_
Use a 2" x 4" block of wood or similar
material, between the jack and the transmission to pre-
vent damage to the transmission case.
Advertenties
Inhoudsopgave
