Inhoudsopgave
Advertenties
ATTACHMENT LIFTS
SECTION 7
B-SERIES
The B-Series incorporates no attachment lift mechanism.
Refer to the manual supplied with each attachment for
mounting instructions.
Transport lift accessory 8-6717
may be added for use with rotary mowers.
C-SERIES
Attachment Mounting Locations
Fig.7-1 C-Series Lift linkage
The lift bellcrank, No. 19 in Fig. 7·1, is actuated by the
lift lever No.1, or on C-141, C-161 Automatic models by a
hydraulic cylinder. The lift linkage, on certain attachments,
connects directly to the bellcrank. Other attachments con-
nect their lift linkage to the lift bar No. 27. Use the follow-
ing chart for correct linkage locations:
7-1
Attachment
linkage
Rotary Mower
Trunnion No. 20 in Hole" An of
and Mid Mount
Bellcrank No. 19. Slip Pin "E"
Cultivator
of Lift Bar No. 27 into attach-
ment linkage.
Dozer Blade and
Trunnion No. 20 in Hole "A" of
Grader Blade
Bellcrank No. 19. Attach blade
linkage to Hole "F" of Lift Bar
No. 27. For additional blade
height, place trunnion No. 20
in Hole "B".
Snowthrower
Attach Snowthrower Linkage to
Hole
"c"
of Bellcrank No. 19.
Tiller, Slot Hitch
Attach Rear Lift Cable to Hole
and Clevis Hitch
"D" of Bellcrank No. 19.
Mid Lift Trunnion Adjustment
Adjust trunnion No. 20, nut No. 23, and eyebolt No. 22
so rubber bumpers on mower press firmly on bottom of
footrests when lift is fully raised.
Rear Lift Trunnion and Chain Adjustment -
Rear Mount Attachments
The chain adjustment has two positions, operational and
transport. For operation, the implement clevis is placed in
the last link of the lift chain.
For transportation, the
second last link is usually used.
The rear lift trunnion, located under the gas tank, is used
to adjust optimum height of the rear lift chain for best use
of each implement used. This rear lift trunnion is a "fine"
adjustment that complements the chain adjustment.
Remove Lift Linkage
Refer to Fig. 7-1 during the following procedure.
1. Remove belt guard.
2. Remove left side panel and footrest.
3. Remove two hairpin cotters No. 14 from lift shaft No.9
or 1.
4. Remove one hairpin cotter No. 21 from chain trunnion
No. 20.
5. Disconnect Dial-A-Hite control rod No. 34.
6. Remove circlip (large) No. 17 from right side of lift
shaft No.1 or 9. Remove paint from shaft.
7. Pull lift lever or shaft No.9 from left side to reveal key
No.18.
B. Remove key No. 18.
9. Remove lift lever or shaft No. 9 and bellcrank No. 19.
Advertenties
Inhoudsopgave
