Inhoudsopgave
Advertenties
SECTION 2
B. If a chain hoist is used, attach the hoist to the drawbar
hitch on C and D-Series tractors and to the rear axle on
B-Series tractors.
• B-SERIES
Apply a coating of rust preventative on the axle shafts
(Texaco Compound "L," Light, Code 1976, or equivalent).
Mount a rear wheel and tire on each axle shaft as shown in
Fig. 2-5, with the tire valve stem to the outside. Use the
shim washers as required for minimum end play. Lower the
tractor, and remove the jack or hoist.
'~
.015 "(Thin)
.050"(Thick}
j
Shim Washers (As Req.'d)
\0~
Fig. 2-5 B-Series Rear Wheel Installation
C AND D-SERI ES
Mount a rear wheel and tire assembly on each axle hub
so the tire valve stem faces inside on the C-Series and out-
side on the D-Series. Secure each wheel and tire assembly
with the lug bolts provided. On C-Series tractors, starting
at the top, tighten every other lug bolt until all are tight.
On D-Series tractors, alternately tighten lug bolts on
opposite sides of the wheel until all are tight. Torque the
lug bolts to 75 to 80 ft. Ibs. {105 to 112 Nml.
Lower the tractor and remove the jack or hoist.
Adjust Tire Pressure
Using a low pressure tire gauge, adjust the tire pressure
in all four tires:
PSI
kg/cm 2
Mount Steering Wheel
BAND C-SERI ES
Front
Rear
12
.85
12
.85
Install the bowed spring washer and plastic spacer over
the steering shaft. With the wheels straight ahead, install
steering wheel so that the spokes form a "Y" and line up
the hole in the wheel hub with the hole in the steering
shaft.
Insert a 1/4 punch through the hole to hold the steering
wheel in position.
Install the 1/4 x 2 spirol pin by
driving it in with a hammer; as the spirol pin is driven in, it
should push the punch out.
2-2
D-SERIES
With the front wheels straight ahead, place the steering
wheel on the steering shaft so that the spokes form a "Y".
Secure the wheel with a 5/8-18 jam nut. Snap the steering
wheel insert into place so the "R", inside the wheel, is
straight when viewed from the driver's seat.
Service the Battery
.&CAUTION&
Electrolyte and battery fluid are poisonous and can
be injurious to eyes, skin, and clothing. In the event
of an accident, flush immediately with a solution of
one part bakin\l soda to four parts water.
Notify
physician immediately.
If baking soda is not imme-
diately available, flush affected area with water. Noti-
fy physician immediately.
1. Remove the battery from the tractor.
Never fill
battery with electrolyte with battery installed in tractor.
2. Use an electrolyte with a specific gravity of 1.260; fill
each cell until the electrolyte (battery acid) is 1/4 to 1/2
inch (6 to 13 mm) over the top of the separators. DO
NOT OVERFI LL.
3. Place the filled dry charged battery on charge before in-
stalling. Charge at 15 amperes for 30 minutes. After
charging, top off each cell with electrolyte.
After battery has been in service, add only low
mineral content water.
DO NOT ADD E LECTRO-
L YTE (battery acid).
~
REAR, (-SERIES
FRONT, B-SERIES
Fig. 2-6 Band C-Series Battery Installation
Advertenties
Inhoudsopgave
