Inhoudsopgave
Advertenties
Fig. 5-13 C-Series Automatic Brake Adjustment
Remove and Replace Motion Control Linkage
,
Fig. 5-14 C-Series Motion Control linkage
1. Remove controls cover plate and left side cover.
2. Remove parking brake lever assembly.
Remove nut
holding pin to rear of motion control lever assembly.
See Fig.
~14.
3. Remove bolt from motion control shaft retaining tab.
4. Release pressure on motion control tension spring.
5. Pull shaft out far enough to expose woodruff key on
left side of shaft.
Remove key.
6. Pull shaft all the way out.
7. Carefully remove motion control handle assembly from
under gas line and electrical harness.
Transmission/Transaxle - Automatic Models
For complete repair operations, refer to Wheel Horse
Automatic Transmission Repair Manual No. A-1391.
~5
SECTION 5
Remove and Replace Transaxle
1. Drain the transaxle oil.
2. Remove knob from drive clutch handle and remove con-
trol cover plate.
3. Disengage transmission drive clutch and slip belt off
drive pulley.
4. Remove seat hinge brackets and seat.
5. Unbolt seat pan and disconnect seat switch wires and
tail light wires (if applicable).
6. Remove seat pan.
7. Remove two (2) bolts holding seat pan support bracket
to top of transaxle. Remove fuel line clamp and conduit
clamp (Ref. 8-Speed, Fig.
~8).
<
8. Close fuel valve and disconnect gas line at tank.
Secure fuel line to steering wheel to prevent f : : J e l
line
from draining.
~--------------.
----
9. Remove two (2) bolts and nuts holding seat pan support
bracket
(Ref. 8-Speed, Fig.
~8).
10. Lift off fuel tank along with both brackets and set tank
aside.
11. Remove nut holding pin to rear of motion control lever
assembly. See Fig.
~14.
12. Remove left side panel.
13. Remove brake rod adjusting nut. (Ref. Fig.
~13).
14. Models with hydraulic lift:
disconnect two hydraulic
lines at pump and mark for replacement (Ref. Fig.
~8).
15. Support frame of tractor and remove 4 bolts holding
transaxle to frame (Ref. 8-Speed, Fig.
~9).
16. Remove transaxle assembly.
To replace transaxle, reverse above procedure.
Refill
with oil. Adjust brake band.
Remove and Replace Input Pulley
1. Remove right rear wheel.
2. Disengage drive clutch and slip belt off drive pulley.
3. Remove hex bolt on shaft and pull pulley.
Remove and Replace Pump/Motor
1. Complete steps 1 through 12 under Transaxle Remove
and Replace.
2. Remove left rear wheel for clearance.
3. Complete steps 13 and 14 under Transaxle Remove and
Replace.
4. Remove two transaxle case bolts holding top of drive
motor and two lower bolts holdi ng bottom of drive
motor to transaxle.
5. Remove pump and motor as an assembly.
Whenever pump/motor are removed from transaxle,
always clean strainer and replace oil filter.
To replace pump/motor, reverse above procedure. Refill
with oil. Adjust brake band.
Advertenties
Inhoudsopgave
