!
SECTION 2
3. Lights
4. PTO clutch and brake
5. Lift system
6. Service and parking brakes
7. Transmission clutch
8. Transmission controls
9. Steering
10. Tractor operation in all speeds forward and reverse
B. Test operation of the safety interlock system. The
engine should NOT start if:
1. a) The clutch pedal is not depressed on manual
transmission models.
b) The brake/return to neutral pedal is not de-
pressed on automatic transmission models.
2. The PTO lever or switch is in the Engaged or On
position.
. On models so equipped, also check the operation of
the seat switch. With the engine running and the PTO
engaged, rise off the tractor's seat - the engine should
shut off.
C. On automatic transmission models, check that the
transmission neutral adjustment is properly set. Oper-
ate the tractor under full throttle and allow it to
thoroughly warm up.
Bring the tractor to a stop
using the brake/return to neutral pedal. Release the
pedal; if the tractor "creeps" in either direction, set
the neutral adjustment as described in Section 5.
NOTES
Check Front Wheel Alignment (D-Series Only)
With the tractor's wheels straight ahead, there should
be a small amount (1/16 to 1/8 inch/l.5 to 3 mm) of
"toe·in" adjustment.
If required, adjust the steering as described in Section
8.
Install Drawbar Hitch Pin (C and D-Series Only)
Install the drawbar hitch pin in the drawbar hitch
and secure with a hairpin cotter.
Install Mower Belt Adjustment Bolt (B-Series Only)
Thread the 3/& 16 nut onto the
3/8-16
x 2 full
thread bolt; thread the bolt into the front side of the
mower hanger bracket, located just behind the front axle.
Tighten the nut against the bracket to secure.
C-161 TWIN
Follow procedure for C-Series.
---~-.~
.....
---~-~--.--
- - - - - - -
..
--
•..
~
- - _
...
- - - - -
.....
~---
..
- - - - - - - -
- - - _
.....
_ . _ - - - - -
- - - - _
...
- -
....
----
...
---~
- - - - - -
- - _
.....
- - - - _
..... .
2-4
- - - - - - - - - - - - - _
.....
_
..
__
. -
-_
.....
_
........
_
..